Boxes.py
SlatwallTypeTray
Type tray - allows only continuous walls
Settings for Finger Joints
angle
style
rectangular
springs
style of the fingers
surroundingspaces
maximum space at the start and end in multiple of normal spaces
edge_width
space below holes of FingerHoleEdge
finger
width of the fingers
play
extra space to allow finger move in and out
space
space between fingers
width
width of finger holes
Settings for Stackable Edges
angle
inside angle of the feet
height
height of the feet
holedistance
distance from finger holes to bottom edge
width
width of the feet
Settings for SlatWallEdges
bottom_hook
hook
spring
stud
none
"spring", "stud" or "none"
edge_width
space below holes of FingerHoleEdge
hook_extra_height
space surrounding connectors (in multiples of thickness)
SlatwallTypeTray Settings
sx
sections left to right in mm. See --sy for format
sy
sections back to front in mm. Possible formats: overallwidth/numberof sections e.g. "250/5"; sectionwidth*numberofsections e.g. "50*5"; section widths separated by ":" e.g. "30:25.5:70
h
inner height in mm (unless outside selected)
hi
inner height of inner walls in mm (unless outside selected)(leave to zero for same as outer walls)
outside
treat sizes as outside measurements that include the walls
bottom_edge
F Finger Joint (opposing side)
h Edge (parallel Finger Joint Holes)
s Stackable (bottom, finger joint holes)
e Straight Edge
edge type for bottom edge
back_height
additional height of the back wall
radius
radius for strengthening walls with the hooks
Default Settings
thickness
thickness of the material
format
ai
dxf
gcode
pdf
plt
ps
svg
svg_Ponoko
format of resulting file
tabs
width of tabs holding the parts in place in mm (not supported everywhere)
debug
print surrounding boxes for some structures
reference
print reference rectangle with given length (zero to disable)
burn
burn correction in mm (bigger values for tighter fit). Use BurnTest in "Parts and Samples" to find the right value.
Generate
Save to URL