Boxes.py

self-Logo

PhoneHolder

Smartphone desk holder

Settings for Finger Joints

angle
style style of the fingers
surroundingspacesmaximum space at the start and end in multiple of normal spaces
edge_widthspace below holes of FingerHoleEdge
fingerwidth of the fingers
playextra space to allow finger move in and out
spacespace between fingers
widthwidth of finger holes

PhoneHolder Settings

phone_heightHeight of the phone.
phone_widthWidth of the phone.
phone_depthDepth of the phone. Used by the bottom support holding the phone, and the side tabs depth as well. Should be at least your material thickness for assembly reasons.
angleangle at which the phone stands, in degrees. 0° is vertical.
bottom_marginHeight of the support below the phone
tab_sizeLength of the tabs holding the phone
bottom_support_spacingSpacing between the two bottom support. Choose a value big enough for the charging cable, without getting in the way of other ports.

Default Settings

thicknessthickness of the material
format format of resulting file
tabswidth of tabs holding the parts in place in mm (not supported everywhere)
debug print surrounding boxes for some structures
referenceprint reference rectangle with given length (zero to disable)
burnburn correction in mm (bigger values for tighter fit). Use BurnTest in "Parts and Samples" to find the right value.


This phone stand holds your phone between two tabs, with access to its
bottom, in order to connect a charger, headphones, and also not to obstruct
the mic.

Default values are currently based on Galaxy S7.