Boxes - Gears

Gears

teeth1		number of teeth
shaft1		diameter of the shaft 1
dpercentage1		percent of the D section of shaft 1 (100 for round shaft)
teeth2		number of teeth in the other size of gears
shaft2		diameter of the shaft2 (zero for same as shaft 1)
dpercentage2		percent of the D section of shaft 1 (0 for same as shaft 1)
modulus		width of teeth in mm
pressure_angle		angle of the teeth touching (in degrees)
profile_shift		in precent of the modulus

thickness		thickness of the material
format		format of resulting file
tabs		width of tabs holding the parts in place in mm (not supported everywhere)
debug		print surrounding boxes for some structures
reference		print reference rectangle with given length (zero to disable)
burn		burn correction in mm (bigger values for tighter fit). Use BurnTest in "Parts and Samples" to find the right value.